Za.Ve.Ro: Trunnion Ball Valves

ZA.VE.RO. S.r.l. (Italy) is a leading manufacturer of ball valves, needle valves and check valves with flanged and threaded or welded ends. <Learn more about Za.Ve.Ro>

3-Way Trunnion Ball Valves - Article 40

3-Way Valves are trunnion mounted, and available from DN 1/4" to 4" screwed or flanged.

Pressures from 200 psi to 6000 psi for screwed and
from 150 to 2500 for flanged ends.

Available with soft seat: PTFE or PEEK for no more then 250°C. For higher temperature or corrosive use, valves with metal seats are supplied.

Data Sheet


Trunnion Ball Valves - Article 85

This valve cover for every type of use. Made from 1/2" to 36" full and reduce bore with gear, actuator, lever or bare stem.

Cryogenic type - metal to metal type for high temperature or abrasive use - 3 way - double block & bleed - underground.

Data Sheet


Actuated Ball Valves - Article 85-75-60

Several years of experience gives Za.Ve.Ro the possibility to install every type of actuator from the most important producers on their valves. All types of actuators can be tested at Za.Ve.Ro's location.

The Data Sheet lists the range of ball valves that can be actuated.

Data Sheet


Underground Ball Valves - Article Underground

All Za.Ve.Ro's valves, floating or trunnion, can be easily adapted to underground use.

The valves are the same of Article 75 or 85 but are fully welded in all parts and endowed with special extension with varying lengths according to the project.

Data Sheet


High Pressure Trunnion Ball Valves - Article 85H

Trunnion type ball valves made in accordance with API6A normative for class of pressures 5000 - 7000 - 10000 - 15000.

These valves have the same contruction as Article 85 but the only seats available are: PEEK (for no more that 200°C) or metal to metal (for high temperature).

Available from DN 1"13/16 to 11".

Data Sheet